35 YEARS OF SERVICE
Providing quality products & on time
delivery at competitive rates since 1973
Our Stock Tank
Capacity = 665 gallons
Dimensions: 89.5" X 77" X 28" High
Features: 1" threaded pipe drain. 4000 psi reinforced concrete.
1. All pre-cast tanks from 320 gallons to 3680 gallons are set in place with the cover already sealed in place. This sealant is applied by experienced employees and the cover lowered into place BEFORE the tank is ever raised out of the mold. This feature saves time and everyone’s money.
.jpg)
2. We manufacture WET cast manhole risers. Because they are wet cast their appearance is smoother than dry cast. Wet casting also allows us to manufacture a one-piece, three-foot section. This allows for quicker installations with FEWER joints. With hundreds of feet of riser on hand and over 90 feet of riser molds, we can guarantee quality and quantity when you need it.
3. A 1000 gallon septic tank with a 28” inlet. Very useful for wet or rock bottom installations.
4. A 2000 gallon holding tank with a 28” inlet. Again, very useful for an area with a high water table or a hole with a rock bottom. This tank is very heavy with a 4” thick floor.
5. All tanks, septic, combination, holding or pump, larger than 1000 gallons have a fifth wall in them. This inside wall is the same height as the outside walls. This wall holds the cover up, the floor down and the walls apart. These tanks are very sturdy.
6. Nine boom or crane trucks, two tag trailers and two semi tractor trailer units dedicated to hauling only concrete tanks. The crane truck is a 2003 Mack with tri-drive. The knuckle boom on this truck can set 20,000 lbs at a reach of 31.5 feet. Wait no more for your tank to be delivered.
7. All the trucks that set tanks have a shop-made front bumper. It is made out of very heavy channel iron. These bumpers enable you to nudge the truck the last few feet to the hole with your backhoe if conditions at the job site require such action.
